The short answer
Paint peels off cabinets when it has bonded to grease or gloss instead of to the cabinet itself. The paint itself is rarely the problem. The failure is almost always in the layer underneath: a kitchen film nobody removed, a factory finish too slick to grip, or a primer that was never made to stick to it. Fix the bond and the paint stays on.
The four usual causes
Almost every peeling cabinet job traces back to one of four mistakes, and often more than one.
1. Kitchen grease left on
Cooking puts a thin film of grease on every surface in a kitchen, and it builds up most where hands touch. Paint applied over that film sticks to the grease, not the wood. Weeks later it lifts in sheets, starting at the pulls. A wipe with a household cleaner does not remove it. It takes a real degreaser, and a rinse to clear any residue.
2. A glossy factory finish that wasn't sanded
Most stained cabinets have a hard, clear factory topcoat. It is designed to resist everything, including new paint. Without sanding to dull it, primer has nothing to grip. The paint looks fine for a while, then scratches off with a fingernail. Sanding doesn't mean taking the finish off. It means scuffing it evenly so the surface is no longer slick.
3. Wall paint, or a primer that doesn't bond
Wall paint is made to stay flexible on drywall. On a cabinet door it stays soft, sticks to itself when doors close, and wears through at the edges. A standard wall primer has the same problem underneath: it isn't made to grip a factory finish. Cabinets need a bonding primer made for slick surfaces, and a cabinet enamel on top.
4. Heavy use before the paint cured
Cabinet enamel is dry to the touch long before it is hard. Doors rehung and slammed, shelves loaded with heavy dishes, or a scrub with an abrasive pad in the first weeks can mark or lift a finish that would have been fine a month later. Our guide on cabinet paint cure time covers what the first month should look like.
Where peeling starts
Peeling starts where hands, heat and water meet the cabinets, and it spreads from there. If paint is going to fail, it shows up first in these places:
- Door edges near the pulls, where fingers bring oils and wear every day.
- Around the sink, where water runs down the face frame and sits on the top edge of the doors below.
- Above the range, where grease and heat are worst.
- The trash pull-out, which gets opened more than any other drawer, often with a knee or a foot.
- The bottom edge of the doors beside the dishwasher, where steam vents out.
If your paint is peeling only in one or two of these spots, the rest may be sound. If it is lifting in flat areas away from hands and water, the bond failed everywhere.
Two tests for existing paint
You can check whether the paint on your cabinets is well bonded with two simple tests. Do both on a door's back side or another spot that doesn't show.
Fingernail test. Press a fingernail into the paint and drag it firmly. Sound paint may get a faint mark but won't lift. If it scrapes off in a curl, it isn't bonded.
Tape test. Use a sharp blade to score a small grid, about six lines each way, through the paint. Press a strip of strong tape over it, rub it down, then pull it off quickly. If the squares stay put, the paint is sound. If squares come off on the tape, the paint won't hold up to another coat on top.
These tests matter if you already have painted cabinets and want them repainted. New paint over poorly bonded old paint fails along with it.
Can a peeling job be saved?
It depends on how much of the paint failed. If peeling is limited to the high-wear spots and the rest passes the tape test, a spot repair works. The loose paint is scraped back to a sound edge, the area is feathered smooth, primed and recoated. If the paint fails the tape test across whole doors, it has to come off. That means stripping or sanding back to the original finish, then starting over with full prep. It's more work than the first job, but trying to paint over loose paint only buries the problem. For scale, Angi puts ordinary repairs before painting at $140 to $500; stripping a failed finish is a bigger job than those repairs.
What a lasting job looks like, step by step
A finish that lasts comes from doing every step in order, without skipping any. Here's the sequence:
- Degrease. Every surface, with a cleaner made for kitchen grease, then rinse.
- Sand. Scuff the existing finish evenly so it is dull everywhere, then remove the dust.
- Repair. Fill dents, loose joints and old hardware holes.
- Prime. A bonding primer, on every face and edge being painted. On oak and other woods with tannins, the primer also needs to block stains.
- Finish. Two coats of cabinet enamel, with the drying and recoat times the maker specifies.
- Cure. Gentle use for the first weeks while the enamel hardens.
This is the same sequence we follow on every kitchen. For how it works in a St. Joseph home, see our cabinet painting process.
Thermofoil and laminate fail differently
Thermofoil and laminate cabinets peel in a different way: the plastic skin comes off the board, not paint off the skin. Thermofoil is a vinyl film heat-formed over MDF. Heat from an oven or a toaster, or steam from a dishwasher, softens the glue, and the film bubbles and pulls away at the edges. Paint can't hold a loose skin down. If thermofoil is tight everywhere, it can be prepped and painted. If it is already lifting, it needs new doors, which is when refacing makes more sense. Our guide to painting vs. refacing vs. replacing covers that decision.
What to ask any cabinet painter before hiring
Five questions will tell you whether a painter's prep will hold up:
- How do you degrease, and with what? "We wipe them down" isn't enough.
- Do you sand every surface before priming?
- Which primer do you use, and is it a bonding primer?
- Which enamel do you use? Is it a cabinet enamel or a wall paint?
- How long before I can use the cabinets normally, and what should I avoid in the first month?
A good painter answers all five without hesitation, and puts the products in writing. Vague answers to the first two questions are the biggest warning sign, because cleaning and sanding are the steps a rushed job skips, and the ones you can't see once the paint is on.
Sources
- Angi, How Much Does It Cost to Paint Kitchen Cabinets?, updated August 2024.
Get a written quote
Send photos of your kitchen, including any spots where paint is already peeling, and we'll reply with a written price. Get a Quote
Rated 4.6 from 37 Google reviews